Hillman’s 5/16 in. diameter x 1-1/2 in. long Steel Hex Head Sleeve Anchors are a reliable solution for mounting fixtures to masonry surfaces. This boxed set of 35 anchors is built for dependable performance in brick, concrete, and hollow block, delivering a flush, secure hold every time.
-
Size and components: 5/16" diameter with a 1-1/2" length; hex head for easy driving; screw included (1-1/2" long) to complete the install.
-
Embedment and hole size: minimum embedment of 1-3/8"; requires a 5/16" drill hole.
-
Material and design: steel sleeve anchors with a high/low thread for a strong grip and reliable expansion in masonry.
-
Applications: ideal for brick, concrete, and hollow block installations—mount shelves, brackets, lighting, pipes, or fixtures that need a solid anchor.
-
Performance: capacity up to 260 lbs per anchor (depends on substrate and correct installation).
-
Packaging: boxed set of 35 anchors, ready to use on the job site.
Why this Hillman sleeve anchor set stands out
Unlike generic fasteners, these sleeve anchors are purpose-built for masonry: as you tighten the included screw, the sleeve expands behind the wall to create a robust, vibration-resistant hold. The hex head design makes insertion and final torque accessible with common wrenches or drivers, even in tight spaces. With a precise 1-3/8" minimum embedment, you get consistent performance in a range of masonry substrates, reducing installation guesswork on the job.
Ideal use cases
- Mounting wall brackets for storage shelves in basements or garages.
- Securing light fixtures, conduit runs, or outdoor fixtures to brick or concrete walls.
- Installing handrails or railing brackets to hollow block or solid masonry structures.
- Attaching heavy hardware where a flush, professional finish is required.
Installation at a glance
- Mark the anchor location and select a drill bit matching the 5/16" hole size.
- Drill a hole to at least 1-3/8" depth, then clean out debris from the hole.
- Insert the 5/16" sleeve anchor until the hex head sits flush against the surface.
- Place the fixture over the anchor hole and drive the included screw to tighten.
- Continue until the sleeve expands behind the masonry for a secure hold. Avoid over-tightening to prevent substrate damage.
Whether you're upgrading a workshop, outfitting a garage, or finishing a masonry project, the Hillman 5/16 in. sleeve anchors deliver a dependable, straightforward mounting solution with ready-to-use hardware and a clear path to solid, lasting results.
